Alex Villa
Super Moderator

Pues mil disculpas .... Arfonzo

I still have the Queen bee(lucky me) However did not have time to flew it again. I already did flew on cumulus flight with another of my flying...

Que esten unidas las soldaduras del jumper en disable no es ningún problema, en realidad el jumper en esa posición no cumple ninguna función. Ese OSD...

Los códigos de desbloqueo deben manejarse via correo privado tal como especifico en las instrucciones, esto para no contaminar los hilos del forum.

Alex, por favor ... Dame el codigo correspondiente al "ID:60277:11843". Gracias

Yes, I agree Vova should had put the warning. When you sell an all in one package you risk inexperienced people to buy it. But I have experienced...

I use FBW as preferred flight mode. You need to get the plane to fly straight and level in FBW mode first, then it will behave in Pos hold, RTH etc....

Your interpretation is correct, with main battery jumper enabled RVOSD will select the highest voltage source to power itself, the camera and the...

The problem is, Rangevideo didn't design a prop neither the motor or the ESC. They just put everything together to make it easier for you. All...

This is why people use to put prop stoppers when using folding propellers on pusher motors(some just make sure the screws are tight enough). I wonder...

Alex ... Para que no preguntaras, lo especifico en el coreo, es el que compre y finalmente funcionaba perfectamente. Del que me dijiste que...

I did erased it, I do manage the forum, but there is very little I can do about orders. That has to be handled via support@rangevideo.com and they...

Like Ommadawn says, is very hard to get the current sensor to fail.

De que OSD estamos hablando? Espero sinceramente que no sea el mismo que ya tratamos mas arriba, esta sería la quinta clave que pides para el mismo y...

Works fine on my PC machine, Windows7 64 and latest Mozilla firefox.

Caballeros .... Lo del "Rx not detected" es algo que sufro a menudo .... por no cambiar la mochila de TX de la emisora .... unos modelos llevan...

"Rx not detected" significa que el OSD no ha detectado señal desde el Rx al inicio. O que el Rx estaba mandando señal de failsafe desde el...

I had something similar when I burnt out my ESC in flight. The motor stopped, and the current went way high, then it dropped to 0.5a. Had to glide...

Just use a y lead off one of your ailerons for the rudder. Works for me.

What are you using to verify the current your batteries are taking to recharge? If you are trusting the reading of the charger, then remember there...

Hi, Alex I've double/triple/quadruple checked those connections. Since everything appears to work correctly now I even ran the Wizard once again...

Check again the Rx to OSD connections. Make sure elevator out goes to RVOSD elevator in and Aileron out goes to aileron in. Have seem this problem...

Well, I don't understand how I could mess that up. I went through the wizard several times and just followed the on-screen directions. I assumed that...

Servo directions should be properly set after you run the wizard... If you do it properly.

Alex, Thanks for the reply. I actually did have everything plugged in and connected correctly and when not in FBW mode everything responded...

The only thing you have to try is here: http://www.rangevideo.com/forum/showthread.php?1530-RVOSD-G5-instructions-%28work-in-progress-%29 Make...

I understand your premise...I've tried just about everything at this time. The Tx setup is conventional (normal ailerons) as per setup instructions....

Vova told me that he found a baro damaged on one of them, the others had a damaged inductor. Hard to know how this happened.

RV repair service is excellent. They can be a bit hit or miss with responding to enquiries, but I have sent my RVOSDs back quite a few times for...