boopidoo
Senior Member

Yes, I agree Vova should had put the warning. When you sell an all in one package you risk inexperienced people to buy it. But I have experienced...

Your interpretation is correct, with main battery jumper enabled RVOSD will select the highest voltage source to power itself, the camera and the...

The problem is, Rangevideo didn't design a prop neither the motor or the ESC. They just put everything together to make it easier for you. All...

This is why people use to put prop stoppers when using folding propellers on pusher motors(some just make sure the screws are tight enough). I wonder...

I did erased it, I do manage the forum, but there is very little I can do about orders. That has to be handled via support@rangevideo.com and they...

Like Ommadawn says, is very hard to get the current sensor to fail.

De que OSD estamos hablando? Espero sinceramente que no sea el mismo que ya tratamos mas arriba, esta sería la quinta clave que pides para el mismo y...

Works fine on my PC machine, Windows7 64 and latest Mozilla firefox.

"Rx not detected" significa que el OSD no ha detectado señal desde el Rx al inicio. O que el Rx estaba mandando señal de failsafe desde el...

Check again the Rx to OSD connections. Make sure elevator out goes to RVOSD elevator in and Aileron out goes to aileron in. Have seem this problem...

Servo directions should be properly set after you run the wizard... If you do it properly.

The only thing you have to try is here: http://www.rangevideo.com/forum/showthread.php?1530-RVOSD-G5-instructions-%28work-in-progress-%29 Make...

Vova told me that he found a baro damaged on one of them, the others had a damaged inductor. Hard to know how this happened.

I recommend you to use a PAL setup if your camera and monitor/goggles can handle it. OSD looks much better and there is better resolution. It will...

It will display properly when the plane is moving. Basically GPS heading depends on having enough speed in order to calculate the direction vector.

If the battery were 100% efficient you could have to put the same amps you put out. On the real world batteries are less efficiency, some energy is...

Part is this: http://www.digikey.com/product-detail/en/744066150/732-1077-2-ND/1638482?cur=USD About the cause of the crash... I think it was BEC...

You better change the servo buffer. It is cheap and does not work to take the risk.

All I can say is that RVOSD software does not crash. I programmed it on assembly language, thus there is a very close control of all processes....

You can't see anything wrong on it, but trust me, the problem is the cable. To be more precise, the problem is where the connector pins are clamped...

El problema puede ser que este firmware lo hice con un decodificador distinto. Prueba: GJ16BL

...tienes que poner el "call sign" a ON...

Your GPS cable or connectors are damaged, need to replace the cable.

Que decirte... Podría empezar por un OSD que compraste en Rangevideo y ahora no recuerdo porque razón decías tener un problema con el. Personalmente...

Código de desbloqueo es: BC8RLU

Tacho, puedes eliminar la ferrita y poner un puente, no debería tener ninguna consecuencia. Hay otros componentes para el filtraje de RF, la ferrita...

No! no puedes conectar el GPS de esa manera. No hay ninguna manera "fácil" de hacerlo. Tiene que ser en el conector:

No, they didn't reversed by themselves. That just can't happen.

This seems like a problem with the camera or camera to OSD connector.

The firmware released on the very first RVOSD 5.1 sold had this ghost AHI(A left over from debug stages). If your OSD is recent then you should not...