mrleenagle
Senior Member

Check again the Rx to OSD connections. Make sure elevator out goes to RVOSD elevator in and Aileron out goes to aileron in. Have seem this problem...

Servo directions should be properly set after you run the wizard... If you do it properly.

The only thing you have to try is here: http://www.rangevideo.com/forum/showthread.php?1530-RVOSD-G5-instructions-%28work-in-progress-%29 Make...

Vova told me that he found a baro damaged on one of them, the others had a damaged inductor. Hard to know how this happened.

I recommend you to use a PAL setup if your camera and monitor/goggles can handle it. OSD looks much better and there is better resolution. It will...

It will display properly when the plane is moving. Basically GPS heading depends on having enough speed in order to calculate the direction vector.

If the battery were 100% efficient you could have to put the same amps you put out. On the real world batteries are less efficiency, some energy is...

Part is this: http://www.digikey.com/product-detail/en/744066150/732-1077-2-ND/1638482?cur=USD About the cause of the crash... I think it was BEC...

You better change the servo buffer. It is cheap and does not work to take the risk.

All I can say is that RVOSD software does not crash. I programmed it on assembly language, thus there is a very close control of all processes....

You can't see anything wrong on it, but trust me, the problem is the cable. To be more precise, the problem is where the connector pins are clamped...

El problema puede ser que este firmware lo hice con un decodificador distinto. Prueba: GJ16BL

...tienes que poner el "call sign" a ON...

Your GPS cable or connectors are damaged, need to replace the cable.

Que decirte... Podría empezar por un OSD que compraste en Rangevideo y ahora no recuerdo porque razón decías tener un problema con el. Personalmente...

Código de desbloqueo es: BC8RLU

Tacho, puedes eliminar la ferrita y poner un puente, no debería tener ninguna consecuencia. Hay otros componentes para el filtraje de RF, la ferrita...

No! no puedes conectar el GPS de esa manera. No hay ninguna manera "fácil" de hacerlo. Tiene que ser en el conector:

No, they didn't reversed by themselves. That just can't happen.

This seems like a problem with the camera or camera to OSD connector.

The firmware released on the very first RVOSD 5.1 sold had this ghost AHI(A left over from debug stages). If your OSD is recent then you should not...

http://www.rangevideo.com/forum/showthread.php?1656-Cycling-screens-now-triggers-Autopilot-after-upgrading-to-RVOSD-v5/page2

Pablo, el problema que tienes está en el cable o los conectores GPS, puedes intentar soldar directamente los cables en el lado del GPS. Éste tiene...

...El problema es que aún no estás usando el set correcto de firmware. La placa gráfica que estás usando tiene una modificación hecha por el usuario...

tancho, Aparentemente algo pasó con este OSD que dañó la entrada de señal del sensor de corriente. Si sabes electrónica o consigues alguien...

Try this: 1- Run the configuration wizard again. 2- Set Altitude control limit to 100 3- Set altitude proportional gain to 40 4- Set altitude...

I need screen capture of all pages.

Seems like something went wrong with U5 replacement. I think that's the cause.

Tancho, estoy algo confundido. Por lo que dices el set de firmware que usaste es correcto. sin embargo me gustaría que me resumieras en un mensaje...

Can you post screen captures of the OSD settings, my guess is that there is something wrong there.