Antena Tacker Again...

[Alex Villa]

No it will not do continuous pan. There is no point on that unless you want the cables to tangle around. MFD antenna tracker can do i because it use slip rings. But then there will be more difficult to have diversity, LCD screen and video splitter on board.

[Acorns]

I'm sure this has been answered somewhere, but a quick search couldn't find it.

Does the RVOSD2 on the most recent firmware for it encode the data the tracker needs? I'm thinking of buying a new RVOSD5, and putting the 2 on a ground vehicle. Being able to watch where it is on the map would be awesome.

[Alex Villa]

I have to check, but I think it doesn't.

[henry74]

Hi Iam sure this was answered before, but I did not find it. About the diversity of the Antenna tracker device, I have plugged two Video Rx one in Main AV and other in Aux AV, and only 1 AV/out to my googles. Supposedly the device takes the better signal, but how do i know which signal is getting in each time ?? does it change leds or something?

Thank you.
Henry

[Alex Villa]

Yes, change leds.

[ommadawn]

Hi Alex,
I removed the fried Schmitt Trigger servo bufffer and bypassed it. P+T now work. The board was charred under the chip so I dont think I can easily replace it. Will try without and see how it goes.
Thank you for all your invaluable support.
Cheers
Frank

[baka]

Does the balance lead input for powering the AT require all 4 pins or does it just take 12v from first and last pin?

[Squawk]

Just Ground and 12V connected on the first and last pin. (Check polarity!)

[baka]

Thanks squawk, consider it triple checked!

[kelly]

the pin closest to the USB port is + by the way