RTH switch setup for Futab 9C Instuctions:

[pshimm]

Thanks Kevo,
I asked Alex and he answered a bunch of my questions. The Gen 4 firmware is different than your Gen 3--so it was a bit hard to follow your instructions. For example, my version requires going into the autopilot menu to adjust the throttle failsafe instead of "set PCM Failsafe" on the main menu of Gen 3. But I think I'll understand it now.
Peter

[Burnt Offering]

Sorry Peter, didn't mean to send you on a wild goose chase. Never seen the menu on a Gen 4. All that matters is you get it working. Let s know how you are progressing.

Kevo

[Alex Villa]

Peter, your version has the "Set throttle FS detect" on the main menu page 1. The only difference is that this was called "Set PCM FS point" on previous versions.

The way I adjust this is:
1-Set throttle on the RC Tx to 110%, store "Set throttle FS detect" at this level on the OSD
2-Set throttle on the RC Tx to 120%, set this as failsafe for throttle channel on the receiver or transmitter, this depends on your RC Tx-Rx system used.
3-Set throttle back to 0-100% travel.
4-Save configuration on the OSD.

Keep in mind that every time you run the RC wizard it will try to reset the "Set throttle FS detect" level. So if you want to save configuration on the OSD after running the wizard you have to repeat step 1.

[pshimm]

yes, my mistake--it is on the main menu. will try that setup. Thanks

[pshimm]

Okay--got it working. Thanks guys!

[webconnector]

hi guys tell me how to do it on the Futaba 8fg thanks