5.8 GHz 600mW wireless video transmitter with microphone and aluminum case

This new transmitter can powered ON without any antenna connected, and will not be damaged. This is handy in case you break your antenna in a crash- this new 25mW transmitter will not burn out.

The race band is a special frequency band with improved channel spacing. This wider channel spacing allows you to run multiple 25mW transmitters at the same time in proximity with each other. Perfect for racing with your buddies.
It is very easy to see and change the band and channel using the push button and LED.

The input voltage for this this 25mW transmitter is 5V-20V.
You can power the transmitter directly from your 2S- 4S Lipo pack.
When the transmitter is powered from 7.0V and higher, it can provide 400mA @5V to power your camera. You can use this to charge a Gopro in-flight, or to power your micro FPV camera.
There is a small solder jumper which you can remove to bypass the 5V regulator and bypass the battery voltage directly to your camera. This is useful if you are using an FPV camera that requires more than 5V.

No heatsink is needed, the transmitter gets barely warm.

A built in microphone is tuned for hearing your motor RPM’s in flight. It works very well with the Headplay HD Goggles, which have a built in speaker.
 

The video and power connector is locking, to prevent it from accidentally coming loose.

Specifications:

40 channels
SMA Antenna connector
Dimensions: 31*22*10mm (not including SMA adapter)
Voltage Input- 7-20V

5-PIN connector:

Line 1: DC-IN (7-20V)

Line 2: GND

Line 3: VIDEO_IN

Line 4: GND

Line 5: 5V_OUT

Frequency band and channel

Single push to change CH, push and hold for 2 seconds to change band.

Below is the channel table for your reference: